When spraying, always backbrush immediately after each section is coated, to ensure a uniform finish. Stir thoroughly with a broad flat paddle before and during use. Wash with a bleach solution and/or demossing chemical to remove mould, or moss. To remove any efflorescence (white salts) wipe down with a 5% solution of acetic acid (white vinegar). Wash down with water using a stiff brush to remove all loose material. Ensure surface is sound¹ and clear of any loose sand or cement. Unpainted masonry surfaces should be cured for 28 days before painting. Dust off.īrick, Masonry, Fibro & Fibre Cement Board Sand all surfaces to a flat finish and remove greyed timber. Fill any cracks or holes with a suitable filler. If not, scrape off all loose and flaking paint. Pre-Primed Timber and Painted Surfaces Test if surface is sound. Dust off and wash with Cabot’s Deck Clean. Note: Cooler conditions could slow down the drying time of the timber.įill any cracks or holes with a suitable filler. Remove excess water from the surface with squeegee on Cabot’s Deck Prep brush, and allow timber to dry for at least 1 hour. Always follow New Timber Prep with Cabot’s Deck Clean following label instructions. New Timber Prep will draw out tannins and oils quickly from the surface, allowing you to skip the 4-6 weeks weathering process required for new timber. To coat new bare timber immediately, scrub damp timber with Cabot’s New Timber Prep, following label instructions.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |